I had mine made 6/2011, these are the parts which were used (the terms I use are not "too official"). There has been some discussion about the push rod 01085730, but according my spare part book the number is the same for 2 plate clutches. Some adjustment was needed on the clutch lever and adjustment screw (for the work cylinder), because it released so "late" with the 2 disc clutch (as if the push rod should be a bit shorter). (Parts only > 1.000€) 12082300 Intermediate clutch ring 1 4082800 Clutch pressure plate V11 1 3008290 Pressure plate for springs 1 1067930 Sprocket wheel for starter 1 4067000 Flywheel V11 1 4211600 Friction plate with sprockets 1 95628025 Nut safety washer 1 93601026 Nut 1 4084100 Clutch spring V11 10 12067701 M8 x 25 bolt, 10.9 6 14615901 M8 Washer zn 6 37067705 M6 x 12 socket cap 12.9 sw 8 142217901 M6 Washer 8 14217901 Lock washer 6,4x10x0,7 8 3084400 Clutch plate Ap 2 90404059 Shaft gasket gear shaft 1 90405367 Shaft gasket crankshaft 1 90706233 O-ring for clutch boss 1 90718370 Gasket exhaust pipe 2
Camn's post in Two plates good, one plate bad. was marked as the answer