Jump to content

Search the Community

Showing results for tags 'Marzocchi fork seals'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Nuts and Bolts: technical questions and topics
    • Technical Topics
  • Reference Section: techniques, procedures and FAQs explained
    • Frequently Asked Questions
    • How to...
  • Moto Guzzi V11 Le Mans: the ride starts here
    • 24/7 V11
    • Special place for banter and conversation
    • Meetings, Clubs & Events
    • Travel & dealers
    • V11 Registries
  • Other Moto Guzzi Models: current bikes and pre-V11 models
    • Newer models
    • Older models
  • About This Site: adverts, housekeeping and site development
    • Classifieds

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


My bike(s)

Found 1 result

  1. I'm replacing my fork oil and decided that it was probably a good idea to replace the seals as they are the originals ... no leakage, but with ~95,000 km figure it's just a matter of time. In searching the forum I saw earemikes reference to seals from Yamaha fitting his forks (Ohlins) and as I also do not have the luxury of a local Guzzi dealer wondered if anyone know of an alternative to the factory seals on the 40mm Marz units ..? I have also read some comments that a seal installer makes things easier - but it's a one-time job and hoping I can get by without? ... comments from anyone whose worked on the 40mm Marzcchi's specifically would be much appreciated. Gio
×
×
  • Create New...