Jump to content

Search the Community

Showing results for tags 'earthing'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Nuts and Bolts: technical questions and topics
    • Technical Topics
  • Reference Section: techniques, procedures and FAQs explained
    • Frequently Asked Questions
    • How to...
  • Moto Guzzi V11 Le Mans: the ride starts here
    • 24/7 V11
    • Special place for banter and conversation
    • Meetings, Clubs & Events
    • Travel & dealers
    • V11 Registries
  • Other Moto Guzzi Models: current bikes and pre-V11 models
    • Newer models
    • Older models
  • About This Site: adverts, housekeeping and site development
    • Classifieds

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Location


My bike(s)

Found 1 result

  1. Hi Guys I have a 2000 V11 sport and have been having electrical problems - after following lots of similar sounding issues already covered in the forum I thought the best thing to do 1st was check earthing contact to gearbox behind seat release lock. This didn't look too bad but I thought I would remove bolt and really clean up contact. The bolt came out ok and I cleaned the gearbox casing and earth strap contact and tried to re insert bolt - which would not engage with the screw thread in the casing.After a frustrating hour and cleaning up the bolt thread I measured the depth of the bolt hole with a very thin screw driver and with much prodding and poking could only insert this about half the length of the bolt. I have checked all other bolts in gearbox / engine casing - nothing moved to cause misalignment now v frustrated and without decent earth can't start any diagnostics - not that I am going to be very good at that either - any ideas - I am a little stumped thanks Sean
×
×
  • Create New...