Kiwi_Roy Posted September 7, 2012 Share Posted September 7, 2012 After much searching I finally managed to find the thermistor used in the air and head temperature sensors This is just the active component, it doesn't come with a plug or housing, all you get is a little blue blob with a couple of wires attached. VISHAY Part No NTCLE203302SB The resistance value is 3000 Ohms at 25°C, the point all thermistors a referenced to. 9.7 KOhms at 0, 202 Ohms at 100, 54 Ohms at 150°C I haven't purchased any yet, I thought I would see if anyone else was interested and make a bulk order, they would be about $2 each including postal, let me know if interested. Roy Thermistor.pdf Link to comment Share on other sites More sharing options...
gstallons Posted September 7, 2012 Share Posted September 7, 2012 Whew..........you have a lot of time on your hands ! Link to comment Share on other sites More sharing options...
Skeeve Posted September 9, 2012 Share Posted September 9, 2012 The resistance value is 3000 Ohms at 25°C, the point all thermistors a referenced to. 9.7 KOhms at 0, 202 Ohms at 100, 54 Ohms at 150°C Thermistor.pdf So, since the thermistor for air temp sensing is never going to get above about 40C, and I don't much expect to ride below about 5C, we can split the difference and average, multiply by the square root of -i, split the infinitive & dot the quarks, and just solder in a 4k ohm resistor to the airbox leads when converting to pods & expect the bike to run a little rich when it's hot outside [as insurance against pinging] and a little lean when it's cold out [to help keep the engine oil from turning into mayonnaise] & call it a day? Thanks! Link to comment Share on other sites More sharing options...
Kiwi_Roy Posted October 22, 2012 Author Share Posted October 22, 2012 VISHAY Part No NTCLE203302SB Thermistor.pdf I had to order some parts the other day so I tacked on some thermistors. If anyone wants one send me a PM with your postal address. They are just the bare little bead with a couple of wires as shown in the attachment, no plug or shroud. The sensor is the same for oil or air temperature When I removed the airbox on my bike I extended the thermistor out to the front at the headstock, without the air flow it would be too hot under the tank, especially for a hot start. Roy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now