Show us your tools

[Nihontochicken]

  On 4/3/2020 at 11:33 PM, Lucky Phil said:

Interesting, do you have a higher res shot so I can see the workings?

Ciao

Expand  

Here's a closer shot of the critical parts (not showing the typical T-handle and bit holder on opposite ends).  I'm quite limited on the size of pictures I can post here, so this is the best I can do after shrinking the frame,  and hence the rather small pics earlier.  Shown also is the original mailing box, but I don't still have the receipt, alas.  Now that I think of it, the tool may have cost closer to $75, but I'm just guessing now, it was a long time ago in a galaxy far, far away.  

Note, I corrected a misstatement in my post above.  "Depending on how far the sliding hammer is rotated with respect to the Delrin buttons, the tool may be used to either tighten or loosen screws or bolts" should instead read "Depending on which way the sliding hammer is rotated with respect to the Delrin buttons, the tool may be used to either tighten or loosen screws or bolts."  Of course, only an idiot would use an impact driver to tighten a fastener, it is generally useful only for loosening.  Some specialized bits to cut new slots in buggered screw heads were supposed to be included with the tool, but Joe was out of them when he sent my example, and I never did get them.  Too bad, they would have been useful in a few cases. 

[docc]

How about a little "Show Us Your Tool Boxes?"

[Lucky Phil]

  On 4/8/2020 at 11:03 PM, docc said:

How about a little "Show Us Your Tool Boxes?"

Expand  

Obviously the "Honda" specific toolbox docc

Ciao

[Chuck]

Ahem. I'm looking for the hammer, and not seeing it..

[Lucky Phil]

  On 4/9/2020 at 12:14 AM, Chuck said:

Ahem. I'm looking for the hammer, and not seeing it..

Expand  

Good pick up Chuck.Although it is a Honda specific kit so maybe they dont need one. 

Ciao

[docc]

I-am-so-busted . . .  

 

[nobleswood]

I'm just wondering where the block plane gets used 

[leroysch]

Shop operates under VFR...

[gstallons]

VFR ?

[Lucky Phil]

  On 4/9/2020 at 12:12 PM, gstallons said:

VFR ?

Expand  

Visual flight rules

Ciao

[LowRyter]

[Kane]

  On 4/9/2020 at 12:29 AM, nobleswood said:

I'm just wondering where the block plane gets used 

Expand  

Me too. Also the pipe wrench and chisels. I think docc is a very clever and resourceful guy. Like the song goes: he does it his way!

[docc]

  On 4/9/2020 at 4:36 PM, Kane said:

Me too. Also the pipe wrench and chisels. I think docc is a very clever and resourceful guy. Like the song goes: he does it his way!

Expand  

Those are my Brembo brake tools!

(Image borrowed from Randy's "I-Talian" thread . . .)

[edit/21 May 2020: bummer: dead image link.]

[docc]

  On 4/9/2020 at 3:22 PM, LowRyter said:

Expand  

"The" cork!     

[LowRyter]

"The Cork"  

 

........ in my tank bag.